TAM-PRO^® M3 Adhesive

• Provides an excellent alternative when hot application is either restricted or simply not feasible
• Smooth, even consistency provides for fast, easy application with a squeegee (squeegee application rate is 1.5–2.0 gallons per 100 square feet)
• Can be applied using spray equipment with an inline heater to significantly enhance worker efficiency
• Side laps and end laps can be heat welded with a hot-air welder or torch, depending on job requirements
• Fewer workers are required to apply TAM-PRO^® M3 Adhesive—and in less time than necessary with traditional hot methods
• Safer to apply, since no kettle or hot asphalt is required as part of the process
• Very few fumes are produced in application, minimizing the odors typical with traditional roofing applications
• Contains petroleum solvents that evaporate quickly, to help assure solid adherence of modified bitumen membrane or base sheet to the roof substrate—while still allowing time to set and reset the rolls into position
• 100% asbestos free
• Squeegee, Spray or Brush application